GOLDONI TWIST 5 Notice D'utilisation Et D'entretien page 74

GOLDONI S.p.A.
maintain a low speed on slopes and
around tight turns;
stay alert for humps and hollows and
other hidden hazards;
take the greatest care when working
across the face of a slope.
Use care when pulling loads or using heavy
equipment:
limit loads to those you can safely
control;
do not turn sharply;
take care when reversing;
use counterweights or wheel ballast to
increase the stability.
Watch out for traffic when crossing or
driving alongside roads.
Do not allow anyone near the machine
while it is operating.
Never operate
defective guards
protective safety
correct positions.
Do not change the engine governor
settings or
Operating the engine at an excessive
speed can increase the hazard of
personal injury.
Before leaving the operator's position:
disengage the drive to any attachments
and lower them;
change into neutral;
turn off the engine.
Disengage the drive to the implements, stop
the engine, disconnect the spark plug wires
and if the electrical start is present, remove
the ignition key
before clearing blockages;
before checking, cleaning, or working
on the machine;
after striking a foreign object. Inspect
EN Inglese
the machine
or without
devices in
over-rev the engine.
the machine for damage and make
repairs before restarting and operating
the equipment;
if
abnormally (check immediately).
Disengage the drive to the implements
when transporting or not in use.
Switch off the engine and disengage drive to
attachment:
before refueling;
before adjusting the implements.
Reduce the speed of the engine before
stopping it. Shut off the fuel supply
once you have stopped working if the
engine is equipped with a shut-off
valve.
Read,
with instructions in the manual and on the
the machine before starting.
their
Inspect the machine before each job.
Only use original spare parts to repair
or replace damaged, very worn or
missing
necessary adjustments before you
start work.
Make sure that all drives are in neutral
before starting the engine.
Start the engine with care and keep
your feet well away from the tools.
Stop the machine if anyone enters the
area in which you are working.
Never leave machine unattended when
it is running.
Take care when approaching blind
corners, shrubs, trees, or other objects
that may impair visibility.
Only
74
the machine starts
understand
components.
use the accessories
TWIST
to vibrate
and follow all
Make the
and
SAFETY