Transport; Storage; Storing The Automatic Lawn Mower; Storing The Base Station - Iseki SRE2600X Notice D'utilisation

Masquer les pouces Voir aussi pour SRE2600X:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Transport

10 TRANSPORT
For transporting the appliance, e.g. from the main
area to the secondary area, proceed as follows:
1.
Stopping the appliance.
2.
Switching off the appliance.
3. Lift the appliance by the carrier bar:
Do not touch the cutting blades.
The cutting blades must always point
away from the body.

11 STORAGE

11.1 Storing the automatic lawn mower

The appliance must be stored over winter or
when it is to be taken out of service for an expec-
ted duration of longer than 30 days.
1. Fully charge the rechargeable battery (see
chapter 5.1 "Charging the rechargeable bat-
tery (09)", page 47).
2. Thoroughly clean the appliance (see chapter
9.1 "Cleaning", page 51).
3. Store the appliance:
upright on all wheels
at a dry, lockable location protected from
frost
out of the reach of children

11.2 Storing the base station

The base station can, but does not have to be put
into storage. However, the storage prevents pre-
mature ageing, such as fading of the colour, cor-
rosion of the charging contacts and the spring
force terminals.
If the base station remains outdoors:
1. Remove the low-voltage cable from the trans-
former and roll together.
2. Put the transformer into storage.
3. Grease the charging contacts with contact
grease.
When the base station is to be put into
storage:
1. First, carry out all work mentioned above.
2. Disconnect the base station from the bound-
ary cable.
3. Remove the base station and remove any
soiling with a broom and a slightly damp
cloth.
456939_a
All manuals and user guides at all-guides.com
4. Store the base station:
at a dry, lockable location protected from
frost
out of the reach of children

11.3 Winter storage of the boundary cable

The boundary cable can remain in the ground
and does not need to be removed.
1. When the base station has been put into stor-
age: Grease the stripped cable ends with
contact grease and wrap with adhesive tape.
This protects the cable ends against corro-
sion.

12 DISPOSAL

Information on the German Electrical and
Electronic Equipment Act (ElectroG)
Electrical and electronic appliances do
not belong in household waste, but
should be collected and disposed of
separately.
Used batteries or rechargeable batter-
ies that are not installed permanently in
the old appliance must be removed be-
fore disposal. Their disposal is regu-
lated by the battery law.
Owners or users of electrical and elec-
tronic appliances are obliged by law to
return them after use.
The end user bears personal respons-
ibility for deleting his personal data
from the old appliance to be disposed
of.
The symbol of the crossed-through rubbish bin
means that electrical and electronic appliances
may not be disposed of in the household rubbish.
Electrical and electronic appliances can be
handed in at no charge at the following places:
Public service disposal or collection points
(e.g. municipal building yards)
Points of sale of electrical appliances (sta-
tionary and online) provided traders are ob-
liged to take them back or offer this voluntar-
ily.
These statements only apply to appliances that
are installed and sold in the countries of the
European Union and are subject to European Dir-
ective 2012/19/EU. Different provisions can apply
to the disposal of electrical and electronic appli-
ances in countries outside the European Union.
53

Publicité

Table des Matières
loading

Table des Matières