Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Displaying information
7.11 Recalibrating
If the position or length of the boundary cable has
been changed or the appliance no longer finds
the boundary cable, recalibration is necessary.
1.
"Reset calibration"
2. "Reset loop calibration data?"
3. Carrying out a calibration movement: see
chapter 5.4 "Carrying out an automatic calib-
ration movement", page 47.
7.12 Restoring factory settings
The factory settings of the appliance can be re-
stored, e.g. before selling the appliance.
1.
*"Factory reset"
message: "Factory reset completed"
8 DISPLAYING INFORMATION
The "Information" menu is used for displaying
machine data. No settings can be made in this
menu.
1.
Call up the main menu.
2.
*"Information"
3.
Select the menu item.
Note: The menu items are described in the
following sections.
4.
Return to the main menu.
"Blades service"
Shows in how many operating hours a blade ser-
vice is required. The counter can be reset manu-
ally. Have the blade service carried out by a
dealer, technician or service partner.
Reset the counter for blade service:
1.
"Confirm"
"Hardware"
Shows information on the appliance, such as
type, year of manufacture, operating hours, serial
identification number, number of mowing inserts,
total mowing time, number of charging cycles,
total charging time, length of the loop of the
boundary cable.
"Software"
Shows the firmware version.
"Program Info"
Shows current settings such as the total weekly
mowing time.
456939_a
All manuals and user guides at all-guides.com
"Failures"
Shows the fault messages that last occurred with
date, time and fault code.
9 MAINTENANCE AND CARE
CAUTION!
Risk of injury
Sharp-edged and moving appliance parts
can lead to injury.
■
Always wear protective gloves during
maintenance, care and cleaning
work.
9.1
Cleaning
IMPORTANT!
Danger from water
Water in the automatic lawn mower and
in the base station leads to damage on
electrical components.
■
Do not spray the automatic lawn
mower and base station with water.
Clean the automatic lawn mower
CAUTION!
Danger of injury due to the cutting
blade
The cutting blades are very sharp and
can cause cutting injuries.
■
Wear protective gloves.
■
Make sure that parts of the body do
not get into the cutting blade.
Once a week, carry out the following:
1.
Switching off the appliance.
2. Wipe off the surface of the housing with a
broom, a brush, a damp cloth or a fine
sponge.
3. Brush off the underside, mower deck and cut-
ting blade with a brush.
4. Check the cutting blade for damage. If neces-
sary, replace the following: see chapter 9.3
"Replacing the cutting blades", page 52.
Cleaning the base station
1. Regularly remove grass residues and leaves
or other objects out of the base station.
2. Wipe off the surface of the base station with
a damp cloth or a fine sponge.
51
Publicité
Table des Matières
