Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
During the calibration movement
To determine the signal strength inside the
boundary cable, the appliance first moves twice
straight beyond the boundary cable and then into
the base station and comes to a stop there. The
rechargeable battery is being charged.
NOTE
The appliance must come to a stop when
it moves into the base station. If the ap-
pliance does not touch the contacts when
it moves into the base station, it moves
further along the boundary cable. If the
appliance moves through the base sta-
tion, the calibration procedure has failed.
In this case, the base station must be
better aligned and the calibration proced-
ure repeated.
After the calibration movement
The pre-set current mowing duration is displayed.
For all further settings, refer to see chapter 7
"Settings", page 48.
6 OPERATION
6.1
Starting the appliance manually
1.
Switch on the appliance.
For unscheduled edge mowing: see chapter
7.7 "Edge mowing with a manual start",
page 50.
2.
Start the appliance manually.
6.2
Cancelling mowing
■
Press the button on the base station
(09/4) or on the appliance.
The appliance moves automatically into the
base station. It deletes the mowing plan of
the current day and starts again the next day
for the set time.
■
Press the button on the appliance.
The mowing is interrupted for half an hour.
■
Press the button on the appliance.
The appliance is switched off.
NOTE
In dangerous situations, the appliance
can be stopped with the STOP but-
ton (09/2).
6.3
Mowing the secondary area (01/NF)
1. Lift the appliance and place in the secondary
area by hand.
48
All manuals and user guides at all-guides.com
2.
Switch on the appliance.
3.
Call up the main menu.
4.
*"Settings"
5.
*"Sub zone mowing"
6. Select the mowing time with
7.
Start the appliance manually.
Depending on the setting: The appliance mows
for the set time period and then switches off or
mows until the rechargeable battery is flat.
After mowing the secondary area, place the ap-
pliance in the base station again by hand.
7 SETTINGS
7.1
Calling up the setting – General
1.
Call up the main menu.
Note: The asterisk * in front of the menu item
indicates that it has just been selected.
2.
*"Settings"
3.
Select the required menu item.
4. Make the settings.
Note: The menu items are described in the
following sections.
5.
Return to the main menu.
NOTE
Further menu items: see chapter 5.2
"Making the basic settings", page 47.
7.2
Setting the cutting height
The cutting height can be adjusted to between
3 – 6 cm with a step width of 1 mm.
1.
*"Cutting Height"
■
*"Cutting Height XXmm": Se-
lect the required cutting height.
■
Press
"Confirm".
The blade plate sets itself to the selected cutting
height first and the blades only begin to turn
when the appliance begins to mow.
7.3
Activating/deactivating the button tones
1.
*"Key clicks"
2. Activating/deactivating the button tones:
■
"Activate"
Activate the button tones.
■
"Deactivate"
Deactivate the button tones.
Operation
.
:
:
SRE2600X
Publicité
Table des Matières
