Publicité
Furthermore, read the following safety precautions: Safety precautions during instal-
lation and Safety precautions during maintenance .
These precautions apply to machinery that use or consume air or inert gasses. The
use of any other gas requires further safety precautions typical of this specific ap-
plication and are not included in this publication. Several precautions are only of a
general nature and refer to various types of equipment and machines; it follows that
some instructions may
not apply to your machine.
1.5 Safety precautions during maintenance or repair
Il produttore declina qualsiasi responsabilità per danni o lesioni derivanti dall'inos-
servanza di queste precauzioni o della normale cautela e dalla mancata attenzio-
ne richieste per l'installazione, il funzionamento, la manutenzione e la riparazione,
anche se non espressamente citata.
Precautions during maintenance or repairs
1. Always wear protective goggles.
2. When carrying out maintenance and repair work exclusively use appropriate tools.
3. Only use original spare parts.
4. Any maintenance work must only be carried out once the machine has cooled off.
5. A warning notice such as "Work in progress; do not start" must be affixed on the starting equipment.
6. Operators starting machines in remote control mode must take opportune precautions to be certain
that no one is checking or working on the machine. For this purpose, a suitable notice must be affixed
on the equipment that can be started in remote mode.
7. Before removing any pressurised component, ensure that the machine is properly isolated from all
sources of pressure, and discharge pressure from the whole system.
8. Never use flammable solvents or carbon tetrachloride to clean the components. Implement precau-
tionary safety measures against toxic emissions from cleaning fluids.
9. Keep the work place scrupulously clean during maintenance and repair works. Protect against dirt by
covering exposed parts and openings with a clean cloth, paper or adhesive tape
10. Do not carry out welding or other operations that could emanate heat close to the lubrication system.
Oil canisters must be thoroughly cleaned, for example by steam, before performing these operations.
instruction manual
7
7
Publicité
