R&G AB0007BK Instructions page 7

one M12 washer onto the bolt, before locating through the adventure bar slot and then sliding the
36mm long front spacer (item 14) onto the bolt. Please use the lefthand side picture on the second
page and picture 14 as a reference.

Offer the adventure bar in place, as shown in picture 15. The front of the adventure bar should also
locate onto the connector slug on the other bar, at the front of the bike, taking care not to let the
bar come in contact with any bodywork, as this may cause damage

Locate the bolts into the frame/engine mounts (there are spacers between the frame and engine on
both bolts which may need to be moved about slightly in order to locate (these can be easily
accessed from underneath with your hand)). Slide the adventure bar onto the connector slug and
loosely tighten the two bolts.

Insert the M6 button head bolt (item 12) from below, as shown in picture 16, before fitting the M6
washer and nyloc nut.

The adventure bars can now be tightened into place. Tighten all the bolts evenly on both sides of
the bike (the four engine/frame mounts no more than 40Nm and the front bracket no more than
20Nm).

Re-fit the original engine/Dual Clutch Transmission cover (if removed) and plastic radiator
surround (if removed) and secure all bolts.

Please check to ensure the bars are correctly mounted and the mounting bolts on the front
subframe have clearance on full lock.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The
Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those
in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for
its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify
any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the
motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained otherwise
than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be
liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or
the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were
purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-
sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value
exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns of
discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty
goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 10/08/2012 (AR)
ISSUE 2 19/11/2012 (AR)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
www.rg-racing.com Email: info@rg-racing.com