R&G AB0007BK Instructions page 6


Ensure all bolts are loosely tightened (enough to leave them a little loose to allow for adjustment
when fitting the second adventure bar).
PICTURE 13
PICTURE 15
Left-hand side (as you sit on bike)

Remove the two engine/frame mounts using a 17mm socket, arrowed in picture 13.

Set the left-hand side adventure bar (item 9) with the bolts, washers and spacers. Take one M12 x
130mm long hex headed bolt (item 13) and slide one M12 washer onto the bolt, before locating
through the adventure bar hole and then sliding one 26mm long rear spacer (item 8) onto the bolt.
For the front mount, take the remaining M12 x 130mm long hex headed bolt (item 13) and slide
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com Email:
PICTURE 14
PICTURE 16
info@rg-racing.com