GoPro HERO3+ BLACK EDITION Mode D'emploi page 66

usInG tHe mounts
aTTaCHInG aDHesIVe MOUnTs
PrO
TIPs:
▶See: gopro.com/support for more information on mounts.
locking Plug
66
HERO3_Plus_Black_UM_ENG_FRA_REVA.indb 66
Apply to clean surface only. Wax, oil, dirt or other debris
will reduce adhesion, which can result in a weak bond
and risk of losing camera should connection fail.
Attach mount in room temperature conditions.
Mount's adhesive will not bond properly if applied in
cold or damp environments to cold or damp surfaces,
or if the surface is not room temperature.
Adhesive mounts should only be mounted to smooth surfaces;
porous or textured surfaces will not enable a proper bond.
When applying mount, firmly press into place and ensure
full contact over entire surface.
For best results, attach the mount 24 hours prior to use.
Using the HERO3+ in high impact sports such as surfing or skiing
where significant impact may occur? Use the special Locking Plug
which securely locks the Quick Release Buckle fingers into place—
helping prevent accidental housing release from the mount.
The circular ring fits over the thumbscrew and acts as a leash
to prevent dropping or losing the locking plug
6/26/13 3:04 PM