Installation - Sharp LL-B270 Mode D'emploi

nAttach the base
Caution
• Be careful not to pinch your fingers.
• Be careful not to touch the LCD panel when you install the
base. Pressure from hands on the LCD panel could cause
damage.
• Check that the base is firmly installed before use.
If the installation is not performed correctly, the monitor
may fall down or the base may drop.
• When transporting, please remove the base before
packing. Transporting with the base attached may cause
damage.
Stand
Soft cloth
(1)
Good
1. Spread out a soft cloth on a flat surface. Be careful
not to damage the monitor, gently lay the monitor on
cloth, display-side down.
2. Attach the base to the stand.
(1) Align the protrusion of the stand with the recess of the
base. Please press firmly so that there is no clearance
between the stand and the base.
*: If gaps are possible, please loosen the screws on
the bottom of the base and then align them.
(2) While attaching the stand and the base to each other
so that there is no gap between them, tighten the
screws on the bottom of the base firmly.
6
E

Installation

nAngle adjustment
Caution
• Be sure to hold both sides of the monitor when adjusting
the viewing angle.
• Pressure from hands on the LCD panel could cause
damage.
(2)
Base
Bad
*
Approx. 5° Approx. 15°