Operating The Tv Using The Remote Control - JVC EX-D5 Manuel D'instructions

This page is for when operating your TV using the
remote control of this product.
Operating the TV using
the remote control
WIRELESS
Setting the manufacturer's code
1
Slide the remote control mode
selector to the TV side.
2
Keep pressing down
NOTE
Keep pressing down TV until Step
3
Press ENTER.
4
Press number buttons (1-9, 0).
Ex.:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
If there are more than one manufacturer's codes,
try them in turn and select the one that causes the
product to work properly.
Manufacturer
JVC
Hitachi
Magnavox
Mitsubishi
Panasonic
RCA
NOTE
Manufacturer's codes may be changed without notice.
You may not be able to operate a TV produced by the
manufacturer shown above.
5
For TV operation
Operate the remote control by pointing it towards
the TV.
*1 Make sure to slide the remote control mode
selector to the TV side in advance.
TV.
NOTE
When the batteries are replaced, perform the
4
is complete.
manufacturer's code setting again.
Code Manufacturer
01 Samsung
10 Sanyo
02 Sharp
03 Sony
04, 11 Toshiba
05 Zenith
Release TV.
Turn ON/OFF the power.
Change channels.
Adjust volume.
9
100+
*1
Alternates between the
previously selected channel
and the current channel.
Switch TV and video input.
Getting started Introduction
Code
12
13
06
07
08
09
Select channels.
7