Adding Fuel / Heating At Nominal Thermal Output; Heating With Brown Coal Briquettes; Banking The Fire And Raising The Temperature; Emptying The Ash Drawer - HASE Luno Mode D'emploi

7.

Adding Fuel / Heating at Nominal Thermal Output

More fuel should be added to the fi re when the fl ames from the
previous burning off phase have just gone out.
Adding Fuel / Heating at Nominal Output
Procedure
Close primary air
Adjust secondary air
Close fi re grate.
Add two logs weighing approx.
1,9 kg in total. Place logs with
one end to the front of fi re box.
Only add a single layer of fuel.
Tab. 2
32
8.

Heating with Brown Coal Briquettes

Wood should be used for the warming-up phase and when
adding fuel for the fi rst time, see "Warming-up Phase". As
soon as a basic glowing fi rebed is reached, place 2-3 brown
coal briquettes on the grate in the middle of the fi rebox, kee-
ping a fi nger's width between the briquettes, and use the
Position of
following procedure and settings:
Control Elements
Set primary air slider (I), all
the way to the right.
Set secondary air slider (I), all
the way to the left.
Open primary air completely.
Push in fi re grate slider.
Adjust secondary air.
Open fi re grate.
Tab. 3
Heating with Brown Coal Briquettes
Procedure Position of
Control Elements
Set primary air slider (I), all the
way to the left.
Half open secondary air
slider [II]
Pull out fi re grate slider.
9.

Banking the Fire and Raising the Temperature

Keep the stove set as described above until the brown coal
briquettes are thoroughly burnt. Then close the primary air (I)
and the fi re grate. Slide the secondary air slider (II) to position
2/3.
CAUTION!
While the stove is in operation, the secondary
air slider should never be completely closed.
To raise the temperature of the fi re, stir up the rest of the glow-
ing embers with the fi re grate slider. Open the primary air (I)
and add new logs to the fi re.

10. Emptying the Ash Drawer

As a safety precaution, please make sure to wait until the
ashes are cold before you dispose of them. While the ash
collects during the fi re, the lid is located under the ash drawer.
Remove both the ash drawer and the lid located underneath
it. Slide the lid onto the ash drawer so that it is closed; this
prevents ashes from fl ying around, which in turn means your
home stays clean. To place the ash drawer back into the stove,
proceed in the reverse order.
CAUTION!
Piled up ashes can impair or even block the
supply of primary air supply to the stove.
Please ensure that the air supply path for the
primary air between the ash drawer and the
bottom of the ash compartment remains clear.