Changing The Type Of Gas Supply - De Dietrich DTE410 Serie Guide D'utilisation

All manuals and user guides at all-guides.com
99632082_ML_A.qxd 11/03/04
C
hanging the type of gas supply
Preliminary remarks
Your hob is delivered regulated for
natural gas.
The injectors for adapting the hob for use
with butane or propane are in the wallet
containing the instructions, together with
the adaptor and the sealing washer.
Please see the corresponding paragraph
on "Gas Connections".
When carrying out this operation, you
should successively:
Adapt the gas connection
Change the injectors
Adjust the retarder on the taps
A
DAPT THE HOB CONNECTION
gas adjustment. Refer to the paragraph
"Gas connections".
C
HANGE THE INJECTORS
way:
• Remove the supports, and all the bur-
ner caps and heads.
• Using the spanner supplied, unscrew
the injectors at the bottom of each dish
and remove them (fig 1).
- Replace these with the injectors
supplied in the wallet, in accordan-
ce with the gas rating table at the
end of the chapter; to do this:
Screw in the injectors by hand un-
til they are tight.
Put the spanner well onto the in-
jector.
With a pencil draw a line on the
hearth plate as indicated (fig. 2).
Turn the spanner alockwise until
the line appears on the other side
(fig. 3). Warning! Do not go
beyond this limit as you are
liable to cause damage.
Put the burner heads, covers and
pan supports back in position.
14:42 Page 29
Installing your hob in all simplicity
In France, this hob can also be
adapted
butane/air. The adaptation pack is
supplied upon request by your After
Sales Service Department.
Every time you change your gas
supply, mark the square on the label
in the wallet that corresponds to the
new type of gas (See "Gas Rating" in
this chapter).
to the new
in the following
Upper side of
the hob
Fig. 2
to propane/air and
Grill
Cover
Head
Dish
Injector
Fig. 1
Spanner
Line
Fig. 3
29