Electrical Connections - De Dietrich DTE410 Serie Guide D'utilisation

All manuals and user guides at all-guides.com
99632082_ML_A.qxd 11/03/04
F
itting recommendations (cont'd)
Place the hob unit into the opening in
the worktop by carefully pulling it
towards you.
Put the burners, caps and pan grates
back into position.
Connect the hob power cable to your
kitchen electricity supply (See "Elec-
trical Connections" for your hob).
If you want, you can fix the hob in posi-
tion on its four corners, using the four
lugs and screws provided (See dia-
gram). Only use the holes
provided.
Stop screwing when the lug
starts to bend.
Do not use a power screwdriver.
E
lectrical connections
Mixed and all-gas hobs
Hobs are delivered with a three-conductor
(phase + ground + neutral) H05V2V2F -
T90, 1mm section cable) AFTER-SALES
SERVICE: 77X3767 (6470.1516) and must
be connected to a 220-240 V~ single phase
mains supply by the intermediary of a
phase + earth + CEI 60083 standardised
neutral plug, or a single pole cut-off devi-
ce with a contact opening by at least
3mm.
The mains plug must be accessible
after installation.
The protective conductor is connected to the
therefore must also be connected to an external earth connection
Use a 10 A fuse.
If the supply cable is damaged it must be replaced by a cable or a special unit available from
the manufacturer or its After-Sales Service.
26
14:41 Page 26
Installing your hob in all simplicity
C
ROSS SECTION OF THE CABLE TO USE
Cable H05V2V2F -
T90
Cross section of
conductors in mm
Fuse
Fixing lugs
F
RONT
B
ACK
W
ORKTOP
220-240 V~ - 50 Hz
All-gas and mixed
conductors of which
1 is to be earthed
1
2
10 A
earth connection on the hob and
.