Electrical Connection - De Dietrich DTI1102VDE Guide D'installation Et D'utilisation

2 2 / / INSTALLING YOUR APPLIANCE
• • ELECTRICAL CONNECTION
Your hob is sold with a H05 VV-F type power
cable with three conductors (cross section
1.5 mm²). Connection to the 220-240V single-
phase mains power supply is carried out using
the power cable fitted with a 2 pole + earth
mains plug or connected to an all-pole cutoff
device in compliance with the installation
regulations in force.
The electrical plug must remain accessible after
installation.
— Connect the wires to the electricity supply,
taking note of the colour of each wire (Fig.01) .
Note
— The safety wire (green and yellow) is connected to the appliance's earth terminal
must be connected to the mains earth terminal
— If the power cable is damaged, it should be replaced by the manufacturer, its after-sales service
department or by a similarly qualified person in order to avoid danger.
— If a cooking hob is used that is not connected to the ground or has a faulty ground electrode, the
manufacturer's liability shall under no circumstances be incurred in the event of an incident or for
any of its consequences.
C
ROSS-SECTION OF CABLE TO BE USED
H05VVF cable
Cross-section of wires
in mm 2
Fuse
Blue wire
Fig. 01
.
39
220-240 V ~ - 50 Hz
3 conductors, including
1 one ground wire
1.5
16 A
Black, brown
or red wire
Neutral
(N)
Phase
(L)
Earth
Green and
yellow wire
EN
and