De Dietrich DTE410 Serie Guide D'utilisation page 28

All manuals and user guides at all-guides.com
99632082_ML_A.qxd 11/03/04
G
as connections (Cont'd)
Possible connections
B
OTTLED OR TANKED GAS
).
PROPANE
For the user's safety, we advise the
connection to be made with a rigid
pipe if this is possible, using a flexible
undulated metal tube with screw-on
connectors (maximum length 2
meters) (fig. A).
For an existing installation, where
it is not possible to fit a reinforced,
braided, flexible gas hose, the
connection can be made with a
flexible gas hose (maximum length 2
metres), with two jubilee clips: one
on the connector (fig. B), and the
other on the pressure regulator, and a
gas proof washer should be fitted
between the connector and the elbow
seal on the hob.
You will find the sealing washer and
the adaptor in the wallet delivered
with the unit.
When connecting the gas supply to
your cooktop, if you find it
necessary to change the direction
of the elbow fitted to the appliance:
Be sure to change the seal (supplied
in the sachet).
Tighten the nut on the elbow, taking
care not to exceed a tightening torque of
17 N.m.
- Temperatures above 30°C would cause overheating of the gas hose. To avoid this, check that there
are no heat-producing devices nearby.
- Screw on the connector with a torque not exceeding 2.5 m/daN (m/kgF).
- In France, you must use a tube or a pipe featuring the "NF Gaz" logo.
28
14:42 Page 28
Installing your hob in all simplicity
( /
BUTANE
BUTANE/PROPANE
Pressure regulator
compulsory.
Q @
Q @
fig. A
Flexible undu-
lated metal
tube with
screw-on
connectors
propane
propane
butanenepropane
Gas proof
washer
(supplied)
Connector
(supplied)
Jubilee clip
(not
supplied)
fig. B
Flexible hose
connection