Operation; Presentation; Operational Modes; Programming - hager HZI810 Mode D'emploi

oPeratIon

Presentation

the product allows :
• sources control,
• automatic transfer control in Aut mode,
• parameters configuration,
* only on HZI 811
software version
Displayed after reset.
(3 minutes power off action to allow reset).
44
All manuals and user guides at all-guides.com
• voltage and frequency metering,
• system state display,
• alarm or fault indication.
Version
number
oPeratIon

operational modes

visualisation
Measuredvalues & parametered timers display. Alway-
saccessible without code.

programming

Parameters configuration. Password access (code
1000 from factory).
the manual mode emust be programmed on an
input if required.
available functions in 43 mode
Programming
Code
Programming Visualisation
available functions in " aut " mode
Programming
Code
Programming Visualisation
test off load
phases rotation control
Function available only on source incase of 3NBL,
4NBL and 41NBL network.
If a fault is detected, the source is not indicated
as available.
45
operation
test sequences. Password access (code 4000).
Operation
Code
Operation
test off load
Operation
Code
Operation
Loss of
test on load
Main's return
main source
sequence
sequence
displayed according to faulty source.
1 2