Fan Mode; Heating Mode; Timer - Oceanic OCEACLIM140W1 Guide D'utilisation

If the water tank is full
When the tank is full, please drain
(For that, please refer to the section "Cleaning and maintenance").

FAN MODE

Press the "MODE" button until the LED FAN
Air flows into the room without being cooled.
Adjust the fan speed by pressing the button
High :
- It is not necessary to connect the drain hose to the window.

HEATING MODE

-Press the MODE button to select the HEAT mode
The corresponding indicator
-Use the buttons and the control panel or the remote control to set the desired target
temperature.
-The heating mode can only work if the ambient temperature is lower than the target
temperature.
-In HEATING mode, install the exhaust hose in order to exhaust the cold air outside.
-Heating mode works if the ambient temperature is between 7 ° C and 25 ° C.
-After using the heating mode, remember to drain the unit.
5. TIMER FUNCTION:
-Allows to program a timer off of the air conditioner
When the appliance operates in mode COOLING, DEHUMIDITY, FAN, HEATING press
the MINUT button (TIMER) on the control panel or remote control to activate this feature.
The corresponding LED will light.
-Press the button
number of hours that you want the device works before stopping automatically.
You can select a time between 1 hour and 24 hours. The unit will stop automatically at
the end of this period. If this function is not selected, the unit will operate continuously.
, the corresponding LED is turned on and an alarm sounds.
The temperature can not be adjusted.
Medium :
lights on the control panel.
as well as increase
65
lights
Low :
.
and decrease to select the