Frost Precautions; Troubleshooting - Zanussi ZWF 91483WH Notice D'utilisation

Frost precautions

If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the
drain pump.
Do this procedure also when you
want to do the emergency drain.
1. Disconnect the mains plug from the mains
socket.
2. Remove the water inlet hose.

Troubleshooting

WARNING!
Refer to Safety chapters.
Introduction
The appliance does not start or it stops during
operation.
First try to find a solution to the problem (refer
to the table). If the problem persists, contact the
Authorised Service Centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
• - The appliance does not fill with water
properly.
• - The appliance does not drain the
water.
• - The appliance door is open or not
closed correctly. Please check the door!
If the appliance is overloaded,
remove some items from the
drum and/or keep pressed the
door and push the
the same time until the indicator
stops flashing (see the
picture below).
www.zanussi.com
All manuals and user guides at all-guides.com
45°
20°
button at
3. Remove the drain hose from the rear
support and unhook it from sink or spigot.
4. Put the ends of the drain and inlet hose in a
container. Let the water flow out of the
hoses.
5. When no more water flows, install the inlet
hose and the drain hose again.
WARNING!
Make sure that the temperature is
more than 0 °C before you use the
appliance again. The manufacturer is
not responsible for damages caused
by low temperatures.
• - The mains supply is unstable. Wait
until the mains supply is stable.
• - No communication between
electronic elements of the appliance. Switch
off and switch on again.
WARNING!
Deactivate the appliance before you
do the checks.
15