Frost Precautions - Zanussi ZWQ 71235SI Notice D'utilisation

CLEANING THE INLET HOSE AND THE VALVE FILTER
1
1
2
3

FROST PRECAUTIONS

If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the drain
pump.
Do this procedure also when you want
to do the emergency drain.
1. Disconnect the mains plug from the mains
socket.
2. Remove the water inlet hose.
3. Remove the drain hose from the rear support
and unhook it from sink or spigot.
4. Put the ends of the drain and inlet hose in a
container. Let the water flow out of the hoses.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
INTRODUCTION
The appliance does not start or it stops during
operation.
First try to find a solution to the problem (refer to
the table). If the problem persists, contact the
Authorised Service Centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
• - The appliance does not fill with water
properly.
14
2 3
5. Set any selected programme with option Drain
& Spin and let it operate until the end of the
cycle.
6. When no more water flows, install the inlet
hose and the drain hose again.
7. Press the On/Off button to deactivate the
appliance.
WARNING! Make sure that the
temperature is more than 0°C before
you use the appliance again. The
manufacturer is not responsible for
damages caused by low temperatures.
• - The appliance does not drain the water.
• - The appliance lid or drum doors are
open or not closed correctly. Please check
both!
• - The mains supply is unstable. Wait until
the mains supply is stable.
• - No communication between electronic
elements of the appliance. Switch off and
switch on again.
WARNING! Deactivate the appliance
before you do the checks.
4
90˚