Emergency Drain; Frost Precautions - Zanussi ZWS76100SS Notice D'utilisation

5
1
2
9
2
1
CLEANING THE INLET HOSE AND THE VALVE FILTER
1
1
2
3

EMERGENCY DRAIN

Because of a malfunction, the appliance cannot
drain the water.
If this occurs, do steps (1) through (10) of
'Cleaning the drain filter'. If necessary, clean the
pump.
When you drain the water with the emergency drain
procedure, you must activate again the drain
system:
1. When you drain the water with the emergency
drain procedure, you must activate again the
drain system: Put 2 litres of water in the main
wash compartment of the detergent dispenser.
2. Start the programme to drain the water

FROST PRECAUTIONS

If the appliance is installed in an area where the
temperature can be less than 0° C, remove the
16
6
10
2
7
3
remaining water from the inlet hose and the drain
pump.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
4. Empty the drain pump. Refer to the emergency
drain procedure.
5. When the drain pump is empty, install the inlet
hose again.
WARNING! Make sure that the
temperature is higher than 0 °C before
you use the appliance again.
The manufacturer is not responsible
for damages caused by low
temperatures.
8
4
45°
20°