Safety Instructions - Zanussi ZWF 91483WH Notice D'utilisation

The operating water pressure at the water entry point from the
•
outlet connection must be between 0.5 bar (0.05 MPa) and 8
bar (0.8 MPa).
The ventilation opening in the base (if applicable) must not be
•
covered by a carpet, mat, or any floor covering.
The appliance must be connected to the water mains using the
•
new supplied hose sets, or other new hose sets supplied by
the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service Centre or
similarly qualified persons to avoid an electrical hazard.
Before any maintenance operation, deactivate the appliance
•
and disconnect the mains plug from the socket.
Do not use high pressure water sprays and/or steam to clean
•
the appliance.
Clean the appliance with a moist cloth. Use only neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.

Safety instructions

Installation
• Remove all the packaging and the transit
bolts.
• Keep the transit bolts in a safe place. If the
appliance is to be moved in future they must
be reattached to lock the drum to prevent
internal damage.
• Always take care when moving the appliance
as it is heavy. Always use safety gloves and
enclosed footwear.
• Do not install or use a damaged appliance.
• Follow the installation instruction supplied
with the appliance.
• Do not install or use the appliance where the
temperature can be less than 0°C or where
it is exposed to the weather.
• The floor area where the appliance is to be
installed must be flat, stable, heat resistant
and clean.
• Make sure that there is air circulation
between the appliance and the floor.
• Adjust the feet to have the necessary space
between the appliance and the flooring.
www.zanussi.com
All manuals and user guides at all-guides.com
• Do not install the appliance where the
• Do not put a container to collect possible
Electrical connection
• The appliance must be earthed.
• Always use a correctly installed shockproof
• Make sure that the parameters on the rating
• Do not use multi-plug adapters and
• Make sure not to cause damage to the
• Connect the mains plug to the mains socket
appliance door cannot be fully opened.
water leakage under the appliance. Contact
the Authorised Service Centre to ensure
which accessories can be used.
socket.
plate are compatible with the electrical
ratings of the mains power supply.
extension cables.
mains plug and to the mains cable. Should
the mains cable need to be replaced, this
must be carried out by our Authorised
Service Centre.
only at the end of the installation. Make sure
3