How To Replace The Needle; Cleaning And Care - auna Fullmatic Mode D'emploi

HOW TO REPLACE THE NEEDLE

Removing the needle from the cartridge
1. Place a screwdriver at the tip of the needle headshell and push
downwards in the direction shown in sketch "A"
2. Remove the needle headshell by pulling it forwards and pushing
downwards.
Inserting the needle
1. Hold the tip of the needle headshell and insert it by pressing in the
direction illustrated by"B".
2. Push the needle headshell upwards In the direction illustrated by "C"
until the needle locks into the tip position.

CLEANING AND CARE

• When opening or closing the turntable cover, handle it gently.
• Do not touch the needle tip with your fingers; avoid bumping the needle
against the turntable platter or record edge.
• Frequently clean the needle tip-use a soft brush in a "back-to-front'
motion only.
• If you must use a needle cleaning fluid, use very sparingly.
• Gently wipe the turntable player housing with a soft cloth. Use only a
small amount of mild detergent to clean the turntable player.
• Never apply harsh chemicals or solvents to any part of the turntable
system.
Guide pin
EN
17