Assembly - auna Fullmatic Mode D'emploi

EN
14
15 PHONO or LINE OUT mode button
RCA output Jack – Connect the RCA line to a mixer or an amplifier
6
in your sound system.
Power adaptor jack – Connect the adaptor to an AC outlet of the
17
proper voltage.
Power – Press it to power on/off the turntable.
18

ASSEMBLY

Drive belt
The belt and turntable platter have been installed properly at factory, but
the belt may be loose during transportation. If so, the following procedures
will be taken for belt installation by yourself:
A. Remove the rubber mat from the turntable platter and the E ring from
the turntable shaft, then release the turntable platter from the shaft.
B. Put the drive belt on the inner rim of the turntable platter and pull it
through the hole
C. Hold the belt with your fingers and place the belt onto the motor pulley
as shown in the drawing.
D. Clip the E ring on the shaft and place the rubber mat onto the turntable
platter.