Prepare For Installation - Kohler K-10950 Mode D'emploi

1. Prepare for Installation

NOTE: When installing this faucet to a 1-1/16" (2.7 cm) to 1-1/4"
(3.2 cm) diameter hole, a single stud configuration should be
employed. When installing this faucet to a 1-1/4" (3.2 cm) to 2-1/2"
(6.4 cm) diameter hole, a two stud configuration should be
employed.
NOTE: The faucet comes configured for a two threaded stud
installation.
For new installations, drill a 2-1/2" (6.4 cm) diameter mounting
hole if there is no existing installation hole.
If installing the faucet on an existing deck, confirm the mounting
hole is a minimum diameter of 1-1/16" (2.7 cm).
If the installation requires a one stud configuration, remove both
studs using a pliers. Take care not to damage the threads.
Reinstall the stud in the single stud mounting hole behind the
flex hoses.
If a single supply of tempered water will be used, remove the
flexible hose from the hot side of the faucet and replace it with
the provided plug.
1025498-2-E
One Stud
Installation
Two Stud
Installation
Stud
4 Kohler Co.