Faucet Installation - Kohler Composed 103C37-SANA-CP Instructions D'installation

1. Faucet Installation

NOTE: Before drilling the mounting hole, use the following
dimensions for proper placement:
A 1-1/4" (32 mm) minimum to 1-1/2" (38 mm) maximum
diameter mounting hole is required.
A minimum distance of 1-3/4" (44 mm) is required between the
back of the spout and the wall to allow access to the screw.
A 1-1/8" (29 mm) maximum distance is required between the
sink bowl edge and the base of the spout.
Install the Faucet
Determine the mounting-hole location.
Drill a hole through the mounting surface according to the
surface manufacturer's instructions.
Install the gasket and plate onto the spout.
Install the stud to the underside of the faucet.
Insert the spout with flexible hoses and stud through the
mounting hole.
Connect the power wire and the supply hose under the sink.
From under the sink, slide the rubber washer and metal washer
onto the stud.
Thread the nut onto the stud and wrench-tighten to secure the
faucet to the mounting surface.
1377340-2-A
Spout
Sensor
O-Ring
Stud
Rubber
Bracket
Washer
Nut
Flexible Hoses
4 Kohler Co.