Kohler Composed 103C37-SANA-CP Instructions D'installation page 10

AC
Supply
AC Gang
Supply
7. Install AC Multi-Output Supply
Mount the AC supply under the counter using two screws
(provided). Orient as shown.
Remove the cover.
Connect the faucet wire to the faucet.
If needed, cut and strip the AC supply wires to length.
Connect the stripped ends to the bottom terminal block in the
supply box.
Secure the terminal box cover to the terminal box.
NOTE: If a hard wired installation is required, refer to "Hard Wire
Installation".
Plug the AC supply into the wall outlet.
Secure any excess wire under the counter.
IMPORTANT! The area in front of the sensor must be free of
objects during the 2 minute learning cycle or the faucet may not
function properly.
Allow 2 minutes for the sensor to cycle through the automatic
sensing distance.
1377340-2-A
Black
Red
10 Kohler Co.