Fantic FAT INTEGRA Livret D'utilisation Et D'entretien page 108

Troubleshooting
08
Problem Possible cause
72 Force applied to pedals not detected.
73 Pedal force sensor connection fault.
74 Errors in the data have been detected.
80 Motor parameters not correct.
81 The speed signal is not recognized.
82 The software has been tampered with.
83 A program sequence error has been de-
tected.
84 Motor parameters incorrect.
EN_42
Possible solution
Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
Make sure that the magnet on the spokes is
correctly positioned in relation to the speed
sensor.
Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
Switch the battery pack off, wait a few
minutes, then switch it on again by press-
ing the push-button present on the bat-
tery pack. If the problem persists, contact
the vendor.
Ed. 1 - 03/2019