Fantic FAT INTEGRA Livret D'utilisation Et D'entretien page 106

Troubleshooting
08
2. ERROR CODES - INSTRUMENT "A"
Check whether the error code that appears on the display is included in the table and, if so, proceed as indi-
cated.
Pay attention to the error codes!
The error codes can denote severe anomalies in the pedelec system. These
anomalies prevent a safe functioning of the pedelec and could cause damag-
es to the system itself or personal injuries. Stop using the pedelec.
Identify the meaning of the error code and please follow the indications in
order to correct it.
If you're not sure of the meaning of the error code, please stop using the sys-
tem and park the bicycle. Please contact the manufacturer, the retailer or its
workshop to find information on how to proceed.
Problem Possible cause
10 Battery pack charge level insufficient.
11 Battery charge level too high.
12 The battery is almost / completely dead.
20 Electrical measurements defective.
21 Heat sensor defective.
24 The internal voltage is outside the operat-
ing range.
25 Motor current measurement error.
EN_40
Possible solution
Recharge the battery pack using the dedi-
cated battery charger.
Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
Recharge the battery pack using the dedi-
cated battery charger.
Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
Recharge the battery pack using the dedi-
cated battery charger.
Turn the system off completely and turn it
back on using the button T4 on the Control
Panel. If the problem persists, please contact
the dealer or the retailer.
>>>
Ed. 1 - 03/2019