Finalizing The Installation - Dometic 8000 Série Manuel D'utilisation

Toilets
6.4 Toilet system with "full tank" shut-down relay and tank monitor system
I
All installations can be set up to include "full tank" shut-down relay and tank monitor
system options . Consult the wiring diagrams included with the product for further
details . Wiring associated with these options needs to be done prior to the next step .
➤ Route the input power wires from the "full tank" shut-down relay to the flush-switch panel .
➤ Proceed to "6 .5 Finalizing the installation" on page 14 .
6.5

Finalizing the installation

26
Toilet
Discharge
Loop Outlet
Discharge
Assembly
I
If installing an 8100 model toilet, perform the following steps prior to proceeding with
the remainder of this section:
➤ Connect the water-valve adapter to the flexible water line with a hose clamp .
➤ Connect the water-valve adapter to the water valve fitting .
8100, 8600, 8700, and 8900 models
➤ Loosen the band clamp on the discharge loop outlet and remove the discharge adapter
fitting/hose fitting assembly .
➤ Lubricate the discharge fitting with a few drops of liquid dish washing soap .
➤ Insert the discharge fitting assembly into the discharge hose and connect them using two
hose clamps .
➤ Position the hose clamp screws 180° from each other .
➤ Place the toilet near the access holes .
➤ Connect the toilet water line to the water supply line .
➤ Make the final wiring connection:
➤ 8600 and 8900 models: Connect the 4-pin connector to the control module cable .
➤ 8100 models: Connect the flush-switch panel wires to the toilet wires .
➤ 8700 models: Connect the 3-pin flush handle connector to the 3-pin wire from the
control module .
EN
27
Water
Supply
Connection
4-Wire
Control
Module
Cable
8100,8600,
8900 models
(Rear View)
Toilet
Flush
Handle
3-Pin Flush
Handle Cable
8700 models
(Rear View)
14