Dometic 8000 Série Manuel D'utilisation page 12

Toilets
20
Mounting
Screws
Touchpad
Cable
4-Wire Control
Module Cable
➤ Ensure that the electrical power is off and install the control module in a cool, dry location .
➤ Secure the flush-switch or touchpad Ethernet cable to the Ethernet connection on the control
module .
➤ Complete the wiring connections to the control module .
I
Before proceeding:
• Refer to the wiring diagram included with the parts list (packed separately) .
• Refer to "5 .3 Wiring/electronic control module connections" on page 9 .
➤ Route the 4-wire control module cable to the toilet through the access hole in the floor .
➤ Proceed to "6 .5 Finalizing the installation" on page 14 .
6.2 Installing the toilet with through-the-wall connections
21
➤ Use the floor template to locate the
vertical centerline of each hole .
➤ Loosen the band clamp on the discharge
loop outlet and remove the straight
discharge hose fitting from the discharge
adapter fitting .
➤ Attach the discharge elbow fitting to the
discharge adapter fitting .
➤ Place the toilet in the desired position and
mark the horizontal centerlines .
➤ Drill the hole sizes according to the template .
EN
Control
Module
22
Template
4-Wire Control
Module Cable
➤ Route the wiring and plumbing through
the drilled holes .
I
➤ Provide extra discharge hose length for
connection to the toilet . Refer to
"4 .2 Minimum system requirements" on
page 5 .
➤ Proceed to "6 .5 Finalizing the installation"
on page 14 .
4-Wire Control
Module Cable
Refer to "5 .3 Wiring/electronic
control module connections" on
page 9 .
12