Dometic 8000 Série Manuel D'utilisation page 13

6.3 Installing a toilet and bidet combination
23
Mounting
Template
➤ Place the floor-mounting template in
the desired location . Keep at least 11"
(279 mm) between the centerline of the
template and any walls or interior fixtures .
➤ Punch through the center of the holes and
mounting bracket corners in the template .
➤ Cut out the oblong access hole as marked
on the floor template .
25
4-Wire Control
Module Cable
➤ Route the wiring and discharge plumbing
through the holes .
➤ Provide extra discharge hose length to
connect to the toilet . Refer to
"4 .2 Minimum system requirements" on
page 5 .
➤ Proceed to "6 .5 Finalizing the installation"
on page 14 .
13
24
Hot-Water Line
➤ Secure the floor brackets to the floor using
the long hex-head screws from the toilet
floor-bracket kit .
➤ Tighten with a 0 .375" (10 mm) socket
wrench, using the corner marks as guides .
I
Do not completely tighten the hex-
head screws to the floor . Brackets will
tighten when fastening the toilet to
the brackets .
➤ Route the cold-water supply line to the
toilet/bidet mixer-valve water line (blue
band) .
➤ Route the hot-water supply line to the
bidet faucet hot-water line (red band) .
Toilets
Cold-Water Line
EN