Overview: Normal Display Representation; Adjusting The Operating Parameters - Nouvag MD 20 Mode D'emploi

MD20

6.4 Overview: Normal display representation

A
B
C
D
A) Program:
Displays the selected program.
B) Transmission ratio:
Displays the selected transmission / reduction or fixed settings.
C) Torque:
Displays the selected torque and when selected, the AL/AS mode.
D) Rotational speed:
Displays the current rotational speed of the motor.
E) Motor:
Displays the selected motor → see also motor jacks control lamps.
F) Pump:
Displays the selected rotational speed of the pump and whether the pump operation is switched on
or off.
The pump only runs when the motor is activated.
G) Direction of rotation:
Shows the direction of rotation.
•
If the rotation occurs counter-clockwise (L left rotation) an audible signal is
heard.
•
The direction of rotation can also be adjusted with the fixed settings compass
saw, oscillating saw, sagittal saw and Mucotom, however, it is insignificant for
the handling process.
6.5.

Adjusting the operating parameters

For the displayed parameters of the display to agree with the actual parameters at the workpiece, the
relevant parameters must first be adjusted on the control device MD20, as explained in the following
steps.
8
All manuals and user guides at all-guides.com
NOUVAG AG
E
F
G
No. 31842 14/06