SilverCrest SLXL 20 A1 Mode D'emploi Et Consignes De Sécurité page 38

All manuals and user guides at all-guides.com
Charging mobile devices with the speaker
♦ Connect the micro-USB plug on the charger cable
charging port on the mobile device to be charged .
♦ Connect the USB type A connector on the charger cable
A socket
♦ Switch on the speaker . The charging process begins automatically .
♦ If charging does not start automatically, press the
the charging process .
NOTE
► Alternatively, you can also use the original charging cable (USB cable)
provided by the respective device manufacturer .
♦ During charging, the current charge level of the speaker is shown via the
charge level LEDs
♦ To stop charging, disconnect the charging cable from the mobile device and
the speaker .
Troubleshooting
The speaker cannot be paired with a compatible Bluetooth
device
Make sure that the Bluetooth
♦
device . When a device is connected via a 3 .5 mm jack cable
Bluetooth
♦ Make sure that the speaker is switched on .
If you use several Bluetooth
♦
is disconnected . There may be a previously paired Bluetooth
range .
Make sure that the speaker is no more than 10 metres from the Bluetooth
♦
device and that no obstacles or electronic devices are placed between them .
You cannot switch on the speaker
♦ The integrated battery in the speaker is empty . Recharge the battery .
You cannot use all of the described functions
This may be down to your Bluetooth
♦
Try updating the software or using a different Bluetooth
SLXL 20 A1
on the speaker .
(see table in the section Checking the charge level) .
®
® function is deactivated .
® devices, ensure that any previous connection
to the micro-USB
button
function is activated on the Bluetooth
® device and its current software .
to the USB type
briefly to start
®
®
, the
® device in
®
® device .
GB │ IE │ 35 ■