Troubleshooting Guide - EINHELL BG-RT 1326 M Mode D'emploi

Anleitung_BG_RT_1326_M_SPK1:_
GB

10. Troubleshooting guide

Fault Possible causes
Motor does not start a) No power at the plug
b) Cable defective
c) Switch/plug block defective
d) Motor terminals or capacitor
e) excessive working depth
Motor performance a) Soil too hard
drops b) Blades badly worn
Important note!
For protection, the motor is equipped with a thermal switch which cuts out when the motor is
overloaded and switches on again automatically after a short cooling period.
14
02.07.2008 15:46 Uhr
disconnected
Seite 14
Remedy
a) Check the power cable and fuse
b) Check
c) By customer service workshop
d) By customer service workshop
e) Reduce working depth
a) Correct working depth
b) Replace hoe blades