Proper Use; Safety Information; Technical Data - EINHELL BG-RT 1326 M Mode D'emploi

Anleitung_BG_RT_1326_M_SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety information

Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Top push bar
2. Bottom push bar
3. Motor unit
4. Hoe blades
5. Cable strain-relief clamp
6. Two-hand safety switch
7. Cable securing clips
8. Two star nuts
9. Six screws
10. Four washers
11. Four circlips
12. Four nuts
10
02.07.2008 15:46 Uhr Seite 10

3. Proper use

The machine is designed for digging soil (for
example garden beds). Be sure to observe the
restrictions in the safety instructions.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
The operating instructions as supplied by the
manufacturer must be kept and referred to in order to
ensure that the machine is properly used and
maintained. The instructions contain valuable
information on operating, maintenance and servicing
conditions.
For safety reasons, the machine may not be used as
a drive unit for other work tools or tool sets of any
kind.

4. Technical data

Voltage
Power input
Working width
Hoe diameter
Idle speed
Number of blades
L noise level
pA
L peak noise level
WA
Vibration at the handlebars a
230V ~ 50Hz
1300 W
26 cm
23 cm
110 rpm
4 pieces
76 dB(A)
93 dB(A)
≤ 2.5 m/s
2
hv