Klarstein ILLUMINOSA Mode D'emploi page 47

DISASSEMBLY (INSTALLER)
Note: Installation/assembly and disassembly of the unit must only be carried out by
qualified personnel.
Before dismantling, any gas in the unit must be vented. Proceed as follows:
• Close all supply valves, but do not disconnect the gas cooker from the line yet.
• Now light all the burners. The remaining gas contained in the appliance burns off in
a short time.
• After that, the appliance's pipes are free of gas and the gas cooker can be
disconnected from the connections.
Important notes on dismantling the unit
• The disassembly is the same as the installation/assembly in the reverse order of the
steps.
• Have a second person help you during disassembly to avoid injury.
• Ensure sufficient ventilation of the working area during disassembly.
• There are no motors or accumulators in this gas hob. Observe the section "Disposal
Considerations".
OPERATION
Important notes on operation
• When the burners or plates are in use do not leave them unattended and make sure
there are no small children in the vicinity. Check that pan handles are positioned
correctly and always keep an eye on the pan whenever oils or fats are used as they
are easily inflammable.
• Do not use spray cans near the appliance when it is in use.
• If the built-in hob has a lid, before opening the lid remove any food deposits from
its surface.
• If the built-in hob has a crystal glass lid, it can explode if heated. Turn in "Off"
position all the burners and switch off all plates. Let the hob become cool before
closing the lid.
• If you see any cracks on the surface of the plate, disconnect the appliance from the
mains immediately.
• After you have used the appliance make sure that all the controls are in "Off"
position.
EN
47