Manual Ignition - Klarstein ILLUMINOSA Mode D'emploi

EN
48
Gas burners
• The burners are graduated in their
size and rating to provide the
exact heat required for every style
of cooking.
• The burners can be equipped
with Flame Safety Device (FSD =
Thermocouple, see figure 5).
• On the top of each knob there is a
printed diagram showing to which
burner or heating element it refers.

Manual ignition

1. Press and turn clockwise the knob corresponding to the burner you wish to use from
"Off" position, until it reaches the "Maximum" position (corresponding to the big
flame, see figure 10) and place a lighted match close to the burner.
2. After ignition, turn the handle from "Maximum" position (corresponding to the big
flame) to "Minimum" position (corresponding to the little flame) and check the
stability of the flame. To turn the burner off, turn clockwise the handle up to "Off"
position.
Automatic electrical ignition
(only certain versions, see figure 9, ref. Ac)
1. The command of lighting is integrated in the control knob. Press and turn
anclockwise the knob corresponding to the burner you wish to use from "Off"
position, until it reaches the "Maximum" position (see figure 10) corresponding to
the big flame. Automatically the ignition spark shoots. Keep the knob pressed until
flame ignition. Matches can be used to light the burners in a blackout.
2. After ignition, turn the handle from "Maximum" position (corresponding to the big
flame) to "Minimum" position (corresponding to the little flame) and check the
stability of the flame. To turn the burner off, turn clockwise the handle up to "Off"
position.
Figure 9
Off position
Maximum position (big flame)
Minimum position (little flame)
Ignite
Figure 10