Hartan Racer Instructions page 16

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
Instructions
Unfolding the pram
By pushing the lock buttons 4, unfold the upper section to bring the handle in
horizontal position. Pull handle 1 upwards until handle catch 2 has engaged.
WARNING! Before using the pram, make sure all catches are locked.
Folding the pram
Turn safety turn-lock 3 inward until the handle's 1 catch has released. Push
handle downwards to fold the pram. By pushing the lock buttons 4, fold the
handle's upper section inward. WARNING! We recommend proceeding with
caution when folding and unfolding the chassis, and adjusting the backrest, as
there is a risk that you do yourself an injury such as jamming your limbs,
fingers, etc.
Changing of wheels
Push the button 5 to release the retention, and pull off the wheel.
Push the wheel right to the axle's stop, and press down the button.
Make sure, all wheels are held in place properly.
Lock-type-swivel wheels (only S and XLS)
Turn down the lock lever 6 to pre-select the straight-line motion mode, which
will be activated as soon as any wheel starts to point in forward direction.
The lever 6 will act on both the right and left wheels as well. To allow the wheels
to swivel freely again, turn the lever 6 back to the horizontal position until
it snaps into place.
ATTENTION!
Remember to clean the wheel blocks on a
regular basis depending on the dirt accumula-
tion degree. Dirt, sand, muddy water, salty
slush, etc. may cause a deposit accumulating
inside the sleeves, and thus restricting the
swivelling movement. Clean the guiding pin as
well as the guiding and locking sleeve using a
damp cloth. If necessary, rinse them out with
clear water, rub them dry, and spray them using
a silicone based lubricant.
Do not use oil! When cleaning the wheel
block, press down the metal clamp to separate
the halves and pull off the lower section.
Parking brake
Push the red brake button 7 to engage the brake.
Having parked the pram, try to push it to check the brake. Push the green brake
button 7 to release the brake. WARNING! Make sure the brake is always
closed when placing the baby in the carriage or taking it out of it.
12
IMPORTANT!
Locking sleeve
Arretierhülse
Guiding sleeve
Führungshülse
A
B
Demontage
Dismounting
Depress metal clamp (A)
A Metallklammer drücken
and pull off wheel block
und B gleichzeitig
(B).
Radblock abziehen.
Guiding pin
Führungszapfen
B
A
Montage
Mounting
Depress metal clamp (A)
A Metallklammer drücken
and slide on wheel block
und B gleichzeitig
(B).
Radblock aufstecken.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Racer sRacer xlRacer xls

Table des Matières