Safety Instructions; Electrical Connection - Progress PVS1550 Notice D'utilisation

by clients in hotels, motels, bed & breakfast and other
–
residential type environments.
Do not change the specification of this appliance.
•
The operating water pressure (minimum and maximum)
•
must be between 0.5 (0.05) / 8 (0.8) bar (MPa)
Obey the maximum number of 9 place settings.
•
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
Put the cutlery in the cutlery basket with the sharp ends
•
pointing down or put them in the cutlery drawer in a
horizontal position with the sharp edges down.
Do not leave the appliance with the open door unattended
•
to avoid stepping accidentally onto it.
Before any maintenance operation, deactivate the appliance
•
and disconnect the mains plug from the socket.
Do not use high pressure water sprays and/or steam to
•
clean the appliance.
If the appliance has ventilation openings in the base, they
•
must not be covered e.g. by a carpet.
The appliance is to be connected to the water mains using
•
the new supplied hose-sets. Old hose sets must not be
reused.

SAFETY INSTRUCTIONS

Installation
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Do not install or use the appliance where
the temperature is less than 0 °C.
• Follow the installation instruction
supplied with the appliance.
• Make sure that the appliance is installed
below and adjacent to safe structures.

Electrical connection

WARNING! Risk of fire and
electrical shock.
All manuals and user guides at all-guides.com
• The appliance must be earthed.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
mains plug and to the mains cable.
Should the mains cable need to be
replaced, this must be carried out by our
Authorised Service Centre.
• Connect the mains plug to the mains
socket only at the end of the installation.
Progress 3