Closing The Door; Installation - Zanussi ZBF22451SA Notice D'utilisation

Masquer les pouces Voir aussi pour ZBF22451SA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the display.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.

Closing the door

1. Clean the door gaskets.

Installation

Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
www.zanussi.com
All manuals and user guides at all-guides.com
Possible cause
This is normal, no error has oc-
curred.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The QuickFreeze or QuickChill
function is switched on.
The appliance is in demonstra-
tion mode.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
The door has been opened of-
ten.
The QuickFreeze function is
switched on.
There is no cold air circulation
in the appliance.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
The compressor starts after a peri-
od of time.
Attach the melting water outlet to
the evaporative tray.
Switch off QuickFreeze or Quick-
Chill manually, or wait until the
function resets automatically to set
the temperature. Refer to "Quick-
Freeze or QuickChill function".
Keep the Mode pressed for approx-
imately 10 seconds until a long
sound is heard and display shuts
off for a short time.
Set a higher/lower temperature.
Let the food products temperature
decrease to room temperature be-
fore storage.
Open the door only if necessary.
Refer to "QuickFreeze function".
Make sure that there is cold air cir-
culation in the appliance.
"Installation".
gaskets. Contact the Authorised Service
Centre.
Climate
Ambient temperature
class
SN
+10°C to + 32°C
Solution
23

Publicité

Table des Matières
loading

Table des Matières