Closing The Door; Installation - Zanussi ZFU27400WA Notice D'utilisation

Problem
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.

Closing the door

1. Clean the door gaskets.

Installation

WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Service Centre
www.zanussi.com
Possible cause
The FastFreeze function is
switched on.
There is no cold air circulation
in the appliance.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and the
wall unit must be at least 100 mm . Ideally,
however, the appliance should not be
positioned below overhanging wall units.
Accurate levelling is ensured by one or more
adjustable feet at the base of the cabinet.
Refer to "FastFreeze function".
Make sure that there is cold air cir-
culation in the appliance.
"Installation".
gaskets. Contact the Authorised Service
Centre.
CAUTION!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
Solution
11