Electrical Connection; Door Reversibility - Zanussi ZFU27400WA Notice D'utilisation

min
100mm
A
20mm

Electrical connection

• Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
• The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not
observed.
• This appliance complies with the E.E.C.
Directives.
Rear spacers
You can find the two spacers in the bag with
documentation.
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
12
B
4
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.

Door reversibility

WARNING!
Before carrying out any operations,
remove the plug from the power
socket.
1. Tilt back the appliance carefully so that the
compressor cannot touch the floor.
2. Remove the plinth.
3. Unscrew and remove the lower hinges.
2
1
3
www.zanussi.com