Technical Data; Installation; Electrical Connection - Zanussi ZFU219WO Notice D'utilisation

If the malfunction shows again, contact the Service
Centre.
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to the
rating plate.

Technical data

For further technical information please refer to the
rating on the internal left side of the appliance and in
the energy label.
Dimensions
Rising Time

Installation

Read the Safety information carefully for your
safety and correct operation of the appliance before
installation.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Climate class
SN
N
ST
T
Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be as least 100 mm. Ideally, however, the appliance
should not be positioned below overhanging wall units.
14
Height
Width
Depth
Ambient temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
Model description
(Mod.)
Product number
(PNC)
Serial number
(S.N.)
1440 mm
554 mm
570 mm
10 hours
Accurate levelling is ensured by one or more adjustable
feet at the base of the cabinet.
Warning! It must be possible to disconnect the
appliance from the mains power supply; the plug
must therefore be easily accessible after installation

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to your
domestic power supply. The appliance must be earthed.
The power supply cable plug is provided with a contact
for this purpose. If the domestic power supply socket is
not earthed, connect the appliance to a separate earth
in compliance with current regulations, consulting a
qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed. This appliance
complies with the E.E.C. Directives.
Rear spacer
In order to ensure the required space behind the
appliances for ventilation, please make sure the rear
spacer bracket is installed before switching on the
appliance. Below is the installation sequence for the
rear spacer:
................................................
................................................
................................................