Zanussi ZFU27400WA Notice D'utilisation page 10

Problem
The compressor operates contin-
ually.
There is too much frost and ice.
The compressor does not start
immediately after pressing the
FastFreeze, or after changing the
temperature.
Temperature cannot be set.
The temperature in the appliance
is too low/too high.
10
Possible cause
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The FastFreeze function is
switched on.
The door is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
The FastFreeze or Shopping-
Mode function is switched on.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
Solution
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on the
rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "FastFreeze function".
Refer to "Closing the door".
Position the water drainage plug in
the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
The compressor starts after a peri-
od of time.
Switch off FastFreeze or Shopping-
Mode manually, or wait until the
function resets automatically to set
the temperature. Refer to "Fast-
Freeze or ShoppingMode function".
Set a higher/lower temperature.
Let the food products temperature
decrease to room temperature be-
fore storage.
Defrost the appliance.
Open the door only if necessary.
www.zanussi.com