Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Location
The appliance should be installed well away from sources of heat
such as radiators, boilers, direct sunlight etc. Ensure that air can
circulate freely around the back of the cabinet. To ensure best per-
formance, if the appliance is positioned below an overhanging wall
unit, the minimum distance between the top of the cabinet and the
wall unit must be at least 100 mm . Ideally, however, the appliance
should not be positioned below overhanging wall units. Accurate
levelling is ensured by one or more adjustable feet at the base of the
cabinet.
If the cabinet is placed in a corner and the side with the hinges fac-
ing the wall, the distance between the wall and the cabinet must be
at least 10 mm to allow the door to open enough so that the shelves
can be removed.
Door reversibility
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
1. Remove the plug from
the power socket.
2. Tilt back the appliance
carefully so that the com-
pressor cannot touch the
floor.
3. Unscrew the adjustable
feet, situated on both sides
at the front.
1) If foreseen
Do a final check to make sure that:
• All screws are tightened.
All manuals and user guides at all-guides.com
4. Remove the lower door
hinge by unscrewing the 2
retaining screws.
5. Remove the hinge pin
from the bottom of the
door.
6. Slot the hinge pin into
the hole in the hinge plate.
7. Take the door off.
8. Refit the upper hinge pin
into the opposite location.
9. Fit the door in place on
the hinge pin.
Warning!
It must be possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.
To change the opening direction of the door, do these
steps:
10. Slot the hinge pin into
the hole in the hinge plate
and relocate the hinge as-
sembly to the opposite lo-
cation and refit using the
retaining screws.
11. Refit the bottom hinge
plate assembly on the op-
posite side, taking care that
the edge of the door is par-
allel with the side of the
cabinet.
• The door opens and closes correctly.
12. Remove and install the
1)
handle
on the opposite
side.
13. Reposition, level the
appliance, wait for at least
four hours and then con-
nect it to the power socket.
35
Publicité
Table des Matières
