Periodic Cleaning; Periods Of Non-Operation - Zanussi ZFT710W Notice D'utilisation

Periodic cleaning

The equipment has to be cleaned regularly:
• clean the inside and accessories with lukewarm water
and some neutral soap.
• regularly check the door seals and wipe clean to ensure
they are clean and free from debris.
• rinse and dry thoroughly.
Important! Do not pull, move or damage any pipes and/or
cables inside the cabinet.
Never use detergents, abrasive powders, highly perfumed
cleaning products or wax polishes to clean the interior as
this will damage the surface and leave a strong odour.
Clean the condenser (black grill) and the compressor at
the back of the appliance with a brush or a vacuum clean-
er. This operation will improve the performance of the ap-
pliance and save electricity consumption.
Important! Take care of not to damage the cooling system.
Many proprietary kitchen surface cleaners contain chemi-
cals that can attack/damage the plastics used in this appli-
ance. For this reason it is recommended that the outer
casing of this appliance is only cleaned with warm water
with a little washing-up liquid added.
After cleaning, reconnect the equipment to the mains sup-
ply.
Defrosting the freezer
A certain amount of frost will always form on the freezer
shelves and around the top compartment.
Defrost the freezer when the frost layer reaches a thickness
of about 3-5 mm.
Important! About 12 hours prior to defrosting, set the
Temperature Regulator toward higher settings , in order to
build up sufficient chill reserve for the interruption in
operation.
To remove the frost, follow the instructions below:
1. Switch off the appliance and disconnect the mains
plug from the mains socket.
2. Remove any stored food, wrap it in several layers of
newspaper and put it in a cool place.
Caution! Do not touch frozen goods with wet hands.
Hands can freeze to the goods.
All manuals and user guides at all-guides.com
3. Leave the door open and insert the plastic scraper in
the appropriate seating at the bottom centre, placing a
basin underneath to collect the defrost water.
In order to speed
up the defrosting
process, place a pot of
warm water in the freez-
er compartment. In ad-
dition, remove pieces of
ice that break away be-
fore defrosting is com-
plete.
4. When defrosting is completed, dry the interior thor-
oughly and keep the scraper for future use.
5. Switch on the appliance.
6. Turn the Temperature Regulator to a medium position
and leave to run for at least 4 hours with the "Freezer
Switch" switch on.
7. After the Red Indicator Light has gone out, reload the
previously removed food into the compartments.
Warning! Never use sharp metal tools to scrape off
frost from the evaporator as you could damage it.
Do not use a mechanical device or any artificial means to
speed up the thawing process other than those
recommended by the manufacturer.
A temperature rise of the frozen food packs, during
defrosting, may shorten their safe storage life.

Periods of non-operation

When the appliance is not in use for long periods, take the
following precautions:
1. disconnect the appliance from electricity supply
2. remove all food
3. defrost and clean the appliance and all accessories
4. leave the door/doors open to prevent unpleasant
smells.
Important! If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside from
spoiling in case of a power failure.
33