Change Of Door Opening Direction; Electrical Connection - Zanussi ZFX 305 W Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Change of door opening direction

Should the setting-up or handling demand it, door-open-
ing direction can be refitted from right-handed to left-hand-
ed.
Following operations are to be done on the basis of fig-
ures and explanations:
Break the circuit of the appliance.
Take the covering of top door holder off, unscrew the
screws fixing the top door holder (2 pieces) and take
it off according to figure.
Take the door off.
Remove the screw fixing the lower door holder and the
other screw fixing the lower door holder and the foot.
Then remove the door holder and the foot as shown in
the Figure.
Loosen the screw fixing the foot opposite the lower
door holder in order to remove the foot.
Fix the door holder and the corresponding foot on the
opposite side and then the other loosened foot at the
former place of the door holder as shown in the
Figure.
Please make sure to place the lower foot
below the door holder. The lower foot is
recognizable by its 4 ribs on the outer surface.
Fit the door to the lower door holding pin.
To fit top door holder remove plastic coverings of door
holder holes carefully (e. g. with a knife) and put them
on the other side.
Fix top door holder with 2 screws in the place set free
being careful that the edge of the door is parallel with
the side of cupboard.
Put the covering of top door holder back.
Put over the handle and the plastic nails on the other
side.
In case you do not want to perform the procedures above,
call the nearest brand-mark service. Technicians will
accomplish the refitting expertly for charge.

Electrical connection

This refrigerator is designed to operate on a
230 V AC ( ~ ) 50 Hz supply.
The plug must be put into a socket with protective
contact. If there is no such, it is recommended to get
an electrician to fit an earthed socket in compliance
with standards near the refrigerator.
This appliance complies with the following E.E.C.
Directives:
73/23 EEC of 19.02.73 (Low Voltage Directive) and
subsequent modifications,
89/336 EEC
of
Compatibility Directive) and subsequent modifica-
tions,
96/57 EEC - 96/09/03 (Energy Efficiency Directive)
and its subsequent amendments.
GB
03.05.89
(Electromagnetic
45

Publicité

Table des Matières
loading

Table des Matières