Closing The Door - Zanussi ZFT11110WA Notice D'utilisation

Problem
There is too much frost
and ice
It is too warm in the freez-
er
It is too cold inside the
freezer
The appliance does not
work at all. Neither cooling
nor lighting works
The appliance does not
cool at all
Green indicator flashing

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
20
Possible cause
Products are not wrapped properly
Doors are not shut properly or do
not close tightly
The Temperature regulator may be
set incorrectly
Temperature regulator may be set
incorrectly
The door does not close tightly or it
is not shut properly
Large quantities of food to be frozen
were put in at the same time
Food placed in the appliance was
too warm
Products to be frozen are placed
too closely to each other
Temperature regulator may be set
incorrectly
Plug is not connected to the mains
socket properly
Power does not reach the appliance Try connecting another electrical de-
The appliance is not switched on
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
Plug is not connected to the mains
socket properly
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
The appliance is not switched on
Temperature Regulator is not on
Temperature sensor problem
Wrap the products better
Check if the doors close well and the
gaskets are undamaged and clean
Set a warmer temperature
Set a lower temperature
Check if the door closes well and the
gasket is undamaged and clean
Insert smaller quantities of food to be
frozen at any one time.
Allow food to cool to room tempera-
ture before storing.
Place the products in a way so that
cold air could circulate among them
Set a warmer temperature
Connect the mains plug properly
vice to the power outlet
Switch on the appliance
Call an electrician
Connect the mains plug properly
Call an electrician
Switch on the appliance
Check the Temperature Regulator
Call the service personnel
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Solution
www.zanussi.com