Installing The Appliance - Zanussi ZBF22451SA Notice D'utilisation

Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the
gasket.
In case you do not want to carry out
the above mentioned operations,
contact the nearest Authorised
Service Centre. The Authorised
Service specialist will carry out the
reversibility of the doors at your cost.

Installing the appliance

Make sure that the mains cable can move freely.
1. If necessary cut the adhesive sealing strip
and then apply it to the appliance as shown
in figure.
2. Drill the unit using a Ø 2.5 mm drill (10 mm
max. penetration), Fix the square fitting to
the appliance.
x
x
3. Push the appliance in the direction of the
arrows (1) until the upper gap cover stops
against the kitchen furniture.
4. Push the appliance in the direction of the
arrows (2) against the cupboard on the
opposite side of the hinge.
5. Make sure that the distance between the
appliance and the cupboard front-edge is
44 mm.
6. The lower hinge cover (in the accessories
bag) makes sure that the distance between
the appliance and the kitchen furniture is
correct.
7. Make sure that the clearance between the
appliance and the cupboard is 4 mm.
8. Open the door. Put the lower hinge cover in
position.
www.zanussi.com
All manuals and user guides at all-guides.com
9. Attach the appliance to the niche with 4
10. Remove the correct part from the hinge
11. Attach the covers (C, D) to the lugs and the
12. Install the vent grille (B), attach the hinge
13. Disconnect the parts (Ha), (Hb), (Hc) and
13mm
Ø 2,5
14. Install the part (Ha) on the inner side of the
15. Push the part (Hc) on the part (Ha).
2
1
screws.
cover (E). Make sure to remove the part DX,
in the case of right hinge, SX in opposite
case.
I
I
hinge holes.
covers (E) to the hinge.
(Hd).
C
D
E
E
B
kitchen furniture.
4mm
44mm
Ha Hb
Hc Hd
25