Lamborghini Caloreclima TORO W Instructions D'utilisation, D'installation Et D'entretien page 168

One direct heating circuit and one DHW circuit with circulating pump
- Schematic diagram
- Electrical connections
After installation, carry out the necessary electrical connections as shown in the wiring diagram.
Then configure the controller as described in the specific section.
1 2 3 4 5 6 7 8
L N
300
19 20 21 22 23 24 25 26 27 28 29 30
138
72
To manage the sliding temperature it is necessary to purchase the external probe accessory code 013018X0
If a hot water tank probe (not supplied) is used, it is necessary to purchase the NTC probe accessory code
1KWMA11W (2 mt.) or code 043005X0 (5 mt.)
If a hot water tank thermostat (not supplied) is used, it is necessary to purchase the accessory kit code
013017X0 (to be connected in place of the Hot Water Tank Probe)
168
9 10 11 12 13 14 15 16 17 18
N
306
130
155
N L
fig. 43
cod. 3541Z071 - Rev 00 - 06/2022
fig. 42
Legend (fig. 42 and fig. 43)
72 1st zone (direct) room thermostat
130 Hot water tank circulating pump
138 External probe
155 Hot water tank probe
300 Anti-Legionella circulating pump
306 1st zone (direct) circulating pump
to 1st zone (direct)
b Hot water tank circuit
M Flow
R Return
I* ISPESL safety devices
(When required - not supplied)
TORO W
EN